Water based, thermal insulating paint for interior walls & ceilings
SurfaPaint ThermoDry Interior is a high quality paint with thermal insulating properties, ideal for interior use
It’s certified by European Cool Roof Council ( ECRC )
SurfaPaint ThermoDry Interior combines a superior quality interior paint with the thermal insulating materials contributing to energy savings during winter and summer. The thermal insulating particles block heat transfer, reﬂect thermal radiation, and create a moisture barrier that can result in signiﬁcant energy savings. As it prevents thermal bridging, it minimises moisture condensation and mould growth. It provides scrub resistance, excellent coverage, anti-fungal action, strong adhesion and coating ﬂexibility. SurfaPaint ThermoDry Interior is an ideal solution for preventing mould growth by eliminating humidity condensation on cold wall surfaces, along with its anti-fungal properties. SurfaPaint ThermoDry is ideal for children’s room, bathrooms, kitchens, hospitals, school buildings, hotels and public areas due to its high wash-ability and scrub resistance. Available in white colour for optimum reflective properties. It can be used as a tinting base for light shades. SurfaPaint ThermoDry Interior is a Cool Coating, certified by the European Cool Roofs Council (ECRC).
Internal surfaces (walls, ceilings, concrete, plaster, board) and wherever emulsion paints are applied.
Applicability: SurfaPaint ThermoDry Interior can be applied directly on interior wall surfaces (masonry, concrete, plaster, drywalls), and wherever water based, acrylic paints are applied. New substrates from cement or masonry should have cured for more than 3-4 weeks before primer application. For better results apply SurfaMix P as a primer.
Preparation: Ensure all surfaces are clean and dry prior to application. Remove any dust and dirt.
Application note: Stir well before application. Do not dilute for bridging gaps and hairline cracks of up to 0,5 mm. For cracks bigger that 1mm, ﬁll the gap with a suitable putty. If thinning is required add up to 10% water by volume. Application temperature should be between 8 – 35oC. Apply 2-3 even coats using a good quality brush, roller or by spraying with a tip of a diameter 1,4mm or more. Do not over-brush. Ensure corners and edges are adequately covered. Additional coats should be applied 4-6 hours after the previous application.
Spreading Rate: 10-12 m²/L.
Drying Time: Typically 1 hour depending upon coat thickness. Low temperatures and high humidity will lengthen drying times.